Victor CUTMASTER Specifications download pdf (Page 29)

CUTMASTER A120

Manual 0-4989 3T-1 INSTALLATION

SECTION 3 TORCH:

INSTALLATION

3T.01 Torch Connections

If necessary, connect the torch to the Power Sup-

ply. Connect only the Thermal Dynamics model

SL100SV / Automation, SL100 / Mechanical

or SL100 / Manual Torch to this power supply.

Maximum torch leads length is 100 feet / 30.5 m,

including extensions.

WARNING

Disconnect primary power at the source before

connecting the torch.

1. Align the ATC male connector (on the

torch lead) with the female receptacle.

Push the male connector into the female

receptacle. The connectors should push

together with a small amount of pressure.

2. Secure the connection by turning the lock-

ing nut clockwise until it clicks. DO NOT

use the locking nut to pull the connection

together. Do not use tools to secure the

connection.

1

2

Art # A-07885

Connecting the Torch to the Power Supply

3. The system is now ready for operation.

Check Air Quality

To test the quality of air:

1. Put the ON / OFF switch in the ON

(up) position.

2. Put the Function Control switch in the SET

position.

3. Place a welding lter lens in front of the

torch and turn ON the air. Do not start an

arc!

Any oil or moisture in the air will be visible

on the lens.

3T.02 CNC Connection

1. Locate the interface connection port on the

rear of the power supply.

Automation Interface

Cable Port

Art # A-08464

2. Note the pin-out of the connector and that

the customer supplied connector matches.

Art # A-08323

Plasma

Start / Stop

Signal

Cutting Machine

OK to Move

3. Connect CNC to the power supply.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 127 128

Comments to this Manuals

No comments